GreensboroElectric elevator platformWhat is the difference in construction process

The foundation base or foundation embedded parts shall be completely embedded in the concrete foundation plate.

8The motor of the hydraulic guideway lifting platform is set around the hoistway， occupying a relatively small area， which improves the utilization rate of the hoistway area.

oGreensboroRemove the hydraulic oil， tighten the connector， remove the oil filter， clean it with compressed air，Electric elevator price manufacturer put it back into the oil tank，NashvilleElectric elevator lifting platformBoost innovation and connect the pipeline. Use new oil instead of using old oil. Otherwise， the moving parts of the hydraulic lifting platform system will accelerate wear.

The landing door and cage door device shall be popularized in the construction site with conditions.

OGizaxEmergency manual valve: in case of power failure， it can make the car emergency descend to the nearest floor position and open the door

CdSetting requirements: the construction electric elevator with multi-shift operation shall implement the delivery system， and the driver shall fill in the delivery record form according to the specification requirements. The driver shall carry out pre-shift inspection and can start the operation only after confirming that there is no error.

Setting requirements: the upper and lower ends of the counterweight shall be equipped with suitable sliding shoes or roller guides.

The landing door must be set at the entrance of each landing platform， the landing door must open towards the landing platform side and the door bolt must be set at the side near the construction electric elevator.

fThe middle rotating shaft of the support rod of the hydraulic lifting platform is inconsistent， which causes the lifting platform to be unable to work normally， and the table has tilted. Please carefully check that the general shear-type aerial work platform was put into the market without strict tilt detection before leaving the factory， resulting in many accidents. For tilt detection， the majority of small enterprises do not pay much attention to the detection of this link，Electric elevator price manufacturer This is why there are so many lifting equipment with this problem. The problems of oil cylinder and power unit system are often the problems of insufficient power and unqualified oil cylinder quality， which are also very important for the enterprise itself.

XThe cable guide frame shall be set in accordance with the operating instructions and specifications.

AInspection standardSafety performance: the electric elevator is equipped with the safety device of the traditional traction elevator， and at the same time， it is also equipped with: overflow valve: it can prevent the system pressure from being too high during the upward movement

mNChain-type electric lifting mechanism: with good guiding mechanism， it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: accurate transmission and high cost.

The construction electric hoist shall be equipped with lightning protection device when it is outside the scope of lightning protection.

The pump body adopts an integrated pump station， which is equipped with imported high-quality pump stations， and can also be selected according to customer requirements to meet customers ideal requirements.

Honest managementnFor multi-shift operation， fill in and submit records as required.

AWhen the construction electric hoist foundation is set on the basement roof， floor or other lower suspended structure， the bearing capacity of the foundation support structure shall be checked.

The problem of how to prolong the service life of hydraulic lifting channels is simply discussed here. Maybe many people do not understand this kind of equipment，Electric elevator price manufacturer especially do not know which factories are consuming such equipment. I suggest that friends can search online， because many people who sell and consume this kind of equipment now have their own official websites，NashvilleElectric elevator lifting platformBoost innovation There are more and more detailed introductions about the knowledge of home care and maintenance on the Internet. The hydraulic electric elevator is a very convenient product to use， but even if it is convenient， there are some things worth paying attention to when it is used， otherwise it may cause unexpected accidents due to improper operation. For example， this product needs to be applied to hydraulic oil. When applying or changing hydraulic oil， it is necessary to find the corresponding type. Different types of hydraulic oil cannot be used indiscriminately. Otherwise， the function of this product will be greatly affected， and even accidents may be caused by the mismatched type of hydraulic oil. In addition，Electric elevator, electric elevator, electric lifting platform, electric hydraulic lifting platform - price manufacturer of electric elevator which can prevent the machine equipment from being damaged due to its own resistance during operation.

aGreensboroIf the actual diameter of the wire rope is reduced by % or more than its nominal diameter due to external wear the wire rope shall be scrapped even if there is no visible broken wire.

qBWhen a rigid mm square or circular flat surface is applied to any position on either side of the door with a normal force of N， the door may not meet the above requirements， but it shall remain safe.; The ground protective fence shall be equipped with a fence door. The fence door shall be considered as a landing door and meet the requirements of the full-height landing door. The clearance through-hole and opening size of the ground protective fence and its closed door shall meet the specification requirements