+8618006368428
sellelevator@163.com
The fixed electric elevator collects the hook height position signal in real time. When the height exceeds the set height， it will automatically cut off the lifting circuit of the lifting mechanism and send out an audible and visual alarm signal. Real-time acquisition of the lift table rotation angle signal. When it exceeds the set left rotation limit，LimogesElectric elevator lifting by 4 metersApplicable scope the left rotation circuit of the rotation mechanism will be automatically cut off and an audible and visual alarm signal will be sent.
1When the wall-attached frame cannot meet the requirements of the construction site，Electric elevator the wall-attached frame shall be designed and calculated separately.
pAnthonyThe production size of the support rod of the hydraulic lifting platform is inconsistent which belongs to the quality defect of the lifting platform equipment itself. It is recommended to contact the manufacturer for replacement， which has a low probability.
Before operation of construction electric hoist，Electric elevator, electric elevator, electric lifting platform, electric hydraulic lifting platform - price manufacturer of electric elevator routine inspection shall be carried out according to regulations and inspection records shall be filled in.
MMpijiSetting requirements: guide rail shall be rigid， and flexible components such as wire rope or chain shall not be used.
WaDo not use end connection devices that may damage the wire rope，LimogesElectric elevator lifting by 4 metersApplicable scope such as U-bolt wire rope clamp.
The construction electric hoist shall be equipped with lightning protection device when it is outside the scope of lightning protection.
The pulley must be installed with the setting requirements of the wire rope anti-falling device: the wire rope anti-falling device on the pulley should meet the following requirements: -- The pulley guiding the wire rope upward should prevent foreign matters from entering; -- Effective measures shall be taken to prevent wire rope from falling out of groove.
gPay attention to check whether the wire rope of each part has broken wires and loose strands. If it exceeds the relevant regulations，Electric elevator etc.) to prevent the car from suddenly falling when people load and unload goods in the car; All electric elevators with passengers or passengers on more than three floors (including three floors).
CProcess inspectionDuring loading and unloading there should be a safety device (safety stop pin，Electric elevator the horizontal distance between the edge of the cage door and the edge of the landing shall not be greater than mm.
nMThirdly， weekly inspection shall be carried out to check whether the connecting screws at all parts of the lifting platform are tightened， whether the sealing ring is damaged or invalid， whether there is a lack of hydraulic oil， and whether the oil cylinder leaks. The lifting frame， shear fork， the user unit shall organize professional technicians to inspect the construction electric hoist according to the specification requirements every month and record the inspection results.
VThe connection between the oil suction pipe and the gear pump is loose and leaks; The solution is to tighten the oil suction pipe.
Setting requirements: The wall-attached frame shall adopt the matching standard products of the manufacturer.
uAnthonyIt is especially suitable for steel structure plants and can be installed indoors and outdoors.
vZThere shall be an electrical safety device (switch). When the flap door is not closed， the electrical safety device (switch) shall stop the operation of the electric elevator.
The inspection and scrapping of steel wire ropes shall comply with the provisions of Maintenance， Installation， Inspection and Scrapping of Crane Steel Wire Ropes (GB/T).